Membrane Firestop Sleeve for Firewall Installation
If the cable outlet is required to be installed inside of the firewall or smoke wall, our Membrane Fire Stop Sleeve will do the job.
This UNIQUE product is an angled fire stop sleeve that cuts it’s own hole and installs in 2 minutes, allowing for a UL Classified path to fish cables inside a firewall. The System creates its own hole with the sharp point on the back side of the sleeve. A bead of caulk (not included) is applied to the back of the system and the sleeve is secured to the wall with expanding anchors.
We make this system in the USA in our own factory. UL listed for fire-rated gypsum board/stud walls.
Available in 1 and 2 inch diameters.
Pictorial Installation Process
System contents: Membrane Firestop Sleeve, bushing, anchors, label and UNIQUE Intumescent Putty.
Prior to installation, remove the anchors, putty, label, and plastic bushing.
Determine the cable wall outlet’s location and place the pointed leading edge of the sleeve plate directly above your cable outlet (above the grid). Carefully drive the Membrane Firestop Sleeve into the wall.
Make sure the plate fits flush against the wall. Now, remove the plate and go on to the next step. Be sure to clean out the back of the wall where the hole was made by the sleeve.
Apply a small bead of non-intumescent firestop caulk to the back of the plate and around the sleeve to seal the Membrane Firestop to the wall. Re-insert the system into the hole you made.
Now, carefully drive the expanding anchors through the face of the system and in the drywall.
There are small slots in the holes for the anchor to grab, allowing you to fully expand the anchor while securing the plate flush to the wall. Note: The Membrane Firestop is now permanently installed. Don’t forget to carefully push the bushing back on. Drop your cables through the sleeve and down to the wall outlet.
Cable load is 40%. Apply an inch thickness of the supplied intumescent putty in the top of the sleeve. Be sure to fill out the Documentation Warning Label. It is recommended that you take a picture of your installed System for future reference.
Threaded Firestop Sleeve System
Threaded Firestop Sleeve is used for new cable installations through a cinder block, cement or masonry firewall or floor. UL Classified for up to 4 hours horizontal...
Split Sleeve Retrofit Fire Stop Firestop
The Split Sleeve System™ is a UL Classified retrofit solution designed for sleeving cables which have already been installed without a sleeve and are in...
New Construction Horizontal Fire Stop Firestop
The Smooth Penetrator is used in new horizontal cable installations for walls rated up to 2 hours. No caulk is required between the sleeve and the wall...
Core Bore Firestop and Seal System for Concrete Floors
Use our UNIQUE Core Bore Seal (CBS) Firestop System to cover, seal and firestop empty core holes in concrete slabs or walls during construction...
STI EZ Firestop Grommet Easily Fire Protect a Single Category 6 Cable 10 Pack
EZ-Firestop® Grommets make sealing penetrations of individual and small bundles of cables through gypsum board walls a...
Assembled in a convenient, easy to carry Cordura case, this kit contains the basic service tools essential for equipment installation, repairs and cable preparations.
Whether it's Fiber Optic, Coax,...