Multi-Code 1 Channel 12-24V Gate Receiver - BFT-109950

Multi-Code 1 Channel 12-24V Gate Receiver - BFT-109950

The BFT-109950 is an auto sensing Multi-Code or Stanley compatible format gate receiver. It eliminates any chance of damage to either the gate operator or itself from running off the wrong voltage. Nearly all gate operators offer either 24 or 12 volts AC or DC as accessory power. Because this receiver is auto sensing, it recognizes the gate operator’s correct voltage. As a result, installers can be assured of always having the correct model gate receiver on the truck.

The receiver can operate from 12-30 volts AC or 10.5-30 volts DC and are normally powered from the gate operator. It's relay contact(s) are rated at 30 VAC/DC up to 5 Amps.

The receiver support transmitters that use the Multi-Code format (300 MHz ), as well as the Stanley compatible (310 MHz ) format. Both formats support 1,024 system codes for the BFT-109950.

The BFT-109950 has a single relay. It is designed for use with automatic gate operators or systems where a remote antenna is needed. This model comes with a 9-inch local antenna, three feet of 75 ohm coaxial cable, and a bulkhead connector for locating the antenna outside the gate operator enclosure. This receiver also include audio test points for connecting audio listening equipment for troubleshooting.

Features:

• Dual frequency — Multi-Code or Stanley compatible; jumper selectable.
• 12–24 Volts AC or DC.
• Auto voltage sensing — no jumpers to set.
• Single relay and two relay models.
• Supplied with whip antenna, three feet of coaxial cable and bulkhead connector

Specifications:

• RF: 300 (Multi-Code) and 310 (Stanley compatible) MHz +/- 250 KHz; both formats support 1,024 system codes (MCS109950) or 512 system codes (MCS302850)
• OUTPUTS: Relay(s): MCS109950 = 1CH and MCS302850 =2CH; each relay is a Form C relay (NC connection available on PCB) rated at 30V AC/DC up to 5 Amps RF Test Points: two test points for connecting of an audio listening device to hear what the receiver is hearing
• INPUTS: Antenna: 75 Ohm F connector Dip Switch: used to set the system code; on the MCS109950, all 10 switches can be used for the system code; the MCS302850 uses switch # 10 from the transmitter to determine which channel it should activate; thus only 9 switches can be used to create the system code
• POWER: 12 - 30 VAC or 10.5 - 30 VDC; 16 mA nominal, 50 mA maximum while relay is triggered
• OPERATING TEMPERATURE: -4°F to +140°F (-20°C to +60°C)
• DIMENSIONS: 3.625 in W x 5.25 in H x 1.5 in D (92 x 133 x 38 mm)
• Electrical Connections: 36” 22AWG wires on removable connectors: Power: red and black wires CH1 Relay: 2 gray wires CH2 Relay: 2 yellow wires
• STANDARD EQUIPMENT: MCS109950 and MCS302850; 9.5” whip antenna, 3 ft coaxial cable, bulkhead connector, mounting hardware
• REGULATORY: FCC Part 15