Outdoor Enclosure 32X24X12 Fiberglass NEMA Enclosure Dual Cooling Fans 120 VAC Outlets Vented

Outdoor Enclosure 32X24X12 Fiberglass NEMA Enclosure Dual Cooling Fans 120 VAC Outlets Vented

Features:

• Dual 4" Vents with Rain Shields to Expel Heat
• Dual Thermostat Controlled Cooling Fans 85 Degree Turn On
• Heavy Duty Fiberglass Reinforced Polyester (FRP) Construction
• Includes Aluminum Equipment Mounting Plate
• (4) 120VAC Outlets
• Dual Quarter-Turn Door Latches
• (4) Mounting Feet Included
• NEMA Type 3R, 3RX / IP24 Rated
• Optional Keyed Lock Set Available

Construction and Features
This rugged enclosure is molded from durable and UV resistant fiberglass reinforced polyester (FRP). The door is fully gasketed making this enclosure suitable for use indoors or outdoors. The door features reinforced hinges and dual quarter-turn latches to secure the enclosure. A drip rail over the door provides additional protection against water dripping into the cabinet while the enclosure is wet.

Power
This configuration consists of the fiberglass NEMA enclosure with hinged lid and a equipment mounting plate with two pre-wired duplex 120VAC power outlets (4 outlets total). The outlet box is easily removable to facilitate wiring to an external power source.

Dual Cooling Fans Ventilation
This enclosure features dual 4" vents and dual thermostat controlled cooling fans. The low noise, high airflow fans helps maintain lower internal temperatures by allowing air to be either pushed or pulled through the enclosure. The fans turns on when the internal temperature reaches 100°F (38°C) and turns off when it drops to 79°F (26°C). Both fans are wired internally so it does not require the use of the AC outlets leaving them available for internal equipment use. Rain shrouds on the front door keep rain water from entering the enclosure, and the internal aluminum mesh filters are removable for cleaning.

Galvanized Steel Equipment Mounting Plate
This configuration consists of the fiberglass NEMA enclosure with hinged lid and a 16 Gauge (1.5mm thick) galvanized steel plate for mounting and securing equipment. The enclosure and plate can be drilled and modified by the installer to suit unique site requirements.